Draw-tite 65015 FRONT MOUNT RECEIVER Bedienungsanleitung PDF herunterladen

Leaf

Spring

Access Hole

For 13/16” Wrench

(Underside Of Frame)

Frame Rail

Frame Bracket

Existing M12 Hex Nut

4 Places

Existing Bumper

Mounting Bolts

Bumper

Bracket

Front Mounted Receiver

Installation Instructions

Ford F-250 HD 4WD, F-350 4WD

Part Numbers:

65015

1. Remove the four (4) M12 hex nuts from bumper mounting bolts.

CAUTION: THE BUMPER IS NOW LOOSE FROM THE VEHICLE. PROVIDE SUPPORT.

NOTE: The bumper may be removed for easier access into frame for hex bolt & block.

2. Raise hitch into position aligning holes in hitch with holes in frame and brackets as shown.

3. Feed hex bolts and spacers through ends of frame rails with pull wire and loosely install through frame and hitch.

4. Reinstall bumper (if applicable) and loosely install hex nuts.

5. Realign bumper and tighten all fasteners to specified torque.

Tighten all M12 fasteners with torque wrench to 68 Lb.-Ft (92 N-m).

Rev. A11-07-05N65015Sheet 1 of 3

z 2005 Cequent Towing Products

Flat Washer, 9/16”Qty. (2)

Pull Wire, 1/2”Qty. (2)

Spacer, 1-1/2” x 2” x 1/4”Qty. (2)

Hex Nut, 9/16”Qty. (2)

Hex Bolt, 9/16”-12 x 1-3/4”Qty. (2)

Tighten all 9/16 GR5 fasteners with torque wrench to 110 Lb.-Ft (149 N-m).

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

Equipment Required:

Wrenches: 13/16”, 15/16”, 21mm

Fastener Kit: K65015

Receiver Shown In Proper Position

Bumper

Drill Bits: None

CARGO CAPACITY – DO NOT EXCEED

500 LB. OR VEHICLE FRONT GROSS

AXLE WEIGHT RATING. (GAWR)

LB. MAX. WINCH LINE PULL

9000

1 2 3

Inhaltsverzeichnis

Seite 1 - Installation Instructions

LeafSpringAccess HoleFor 13/16” Wrench(Underside Of Frame)Frame RailFrame BracketExisting M12 Hex Nut4 PlacesExisting BumperMounting BoltsBumperBumper

Seite 2 - Instructions d’installation

Ressortà lamesOrifice d’accèspour clé 13/16 po(sous le longeron)Longeron de châssisSupport de longeronÉcrou hexagonal M12 existant4 endroitsBoulons de

Seite 3 - Instrucciones de instalación

Resorte de hojaOrificio de accesopara llave inglesa 13/16”(superficie inferior del bastidor)Larguero del bastidorSoporte del bastidorTuerca hexagonal