Draw-tite 65048 FRONT MOUNT RECEIVER Bedienungsanleitung PDF herunterladen

Front Mounted Receiver

Installation Instructions

Jeep Wrangler

Part Numbers:

65048

1. Remove, if present, plastic shield, OEM tow hooks, and upper bumper bolts.

2. See proper figure for fastener installation.

3. If desired, trim and reattach plastic shield. CONSULT VEHICLE OWNER BEFORE TRIMMING.

NOTE: DO NOT REATTACH TOW HOOKS.

Tighten all M10 CL10.9 fasteners with torque wrench to 50 Lb.-Ft (68 N-m).

Rev. A2-17-0665048NSheet 1 of 3z 2006 Cequent Towing Products

Spacer, 1-1/2” x 2” x 1/4”, Zinc Plated

Qty.

(2)

Flat Washer, 7/16”

Qty.

(6)

Spacer, 1-1/2” x 2” x 1/4”, Painted Black

Qty.

(2)

Conical Washer, 3/8”

Qty.

(2)

Conical Washer, 1/2”

Qty.

(4)

Hex Bolt, M10 x 1.50 x 45

Qty.

(2)

Hex Bolt, 1/2”-13 x 1-3/4”

Qty.

(4)

Tighten all 1/2” GR5 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body

panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety

precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.

Regulation V-5 and SAE J684.

Equipment Required:

Wrenches: 10mm, 15mm, T-45 or T-55

Drill Bits: None

Fastener Kit: 65048F

CARGO CAPACITY – DO NOT EXCEED

300 LB. OR VEHICLE FRONT GROSS

AXLE WEIGHT RATING. (GAWR)

LB. MAX. WINCH LINE PULL

9000

Receiver Shown In Proper Position

Bumper

Remove

Existing Fasteners

Recovery

Eye

FIGURE 1

1997 And Later

Remove

Existing Fasteners

FIGURE 2

1987 Through 1996

1 2 3

Inhaltsverzeichnis

Seite 1 - Installation Instructions

Front Mounted ReceiverInstallation InstructionsJeep WranglerPart Numbers:650481. Remove, if present, plastic shield, OEM tow hooks, and upper bumper b

Seite 2 - Instructions d’installation

Récepteur d’attelage à montage sur l’avantInstructions d’installationJeep WranglerNuméro de pièce :650481. Enlever, s’ils sont présents, le panneau de

Seite 3 - Instrucciones de instalación

Retire los tornillosexistentesOjode recuperaciónFIGURA 1Modelos 1997 y posterioresReceptor frontalInstrucciones de instalaciónJeep WranglerNúmeros de