Draw-tite 65053 FRONT MOUNT RECEIVER Bedienungsanleitung PDF herunterladen

Front Mounted Receiver

Installation Instructions

Ford Econoline

Note: Fascia trim required.

Obtain vehicle owners approval

before cutting

Part Numbers:

65053

1. Remove splash guard (4) bolts. See Figure 5. Illustration on last page.

2. If present (E-350 &E-450) remove any plastic rivets from (see Figure 3) forward attachment on vehicle. Fold plastic between plastic covering and frame rail.

3. Enlarge forward hole on vehicle with a 1/2 drill bit.

4. Trim lower fascia as shown in Figure 4. Illustration on last page.

5. Feed carriage bolts and spacers thru access point at forward end of frame rail (E-150 & E-250) using a pull wire as shown. See Figure 2. Note: On E-350 &

E-450 loosen bolts at the end of the frame rail (See Figure 3) and bumper bracket enough to feed fasteners into the opening at the end of the frame rail. Do

not remove bolts completely. See Figure 3. The bumper may shift downward slightly. After feeding fasteners into frame rail, raise and retighten bolts.

6. Raise hitch into position and fasten as shown above.

7. Return splash guard to owner or obtain owner permission to trim splash guard as shown in Figure 5. Illustration on last page. Trimming recommended

Tighten all 1/2 GR5 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).

Rev. B11-10-0865053NSheet 1 of 4

z 2008 Cequent Towing Products

Conical Toothed Washer, 1/2”Qty. (4)

Pull WireQty. (4)

Spacer, 1/4” x 1” x 3”Qty. (4)

Nut, 1/2”Qty. (4)

Carriage Bolt, 1/2”-13 x 1-3/4”Qty. (4)

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

Drill Bits: 3/8” & 1/2”

CARGO CAPACITY – Do not exceed

500 LB. (227 Kg) or Truck Front

Gross Axle Weight Rating, (GAWR).

MAXIMUM WINCH LINE PULL

9,000 lb.

MAXIMUM WINCH LINE PULL

(4086 Kg)

Note: Fasteners typical

both sides

Fascia trim required. Obtain vehicle

owners approval before cutting

NOTE: If front mounted license plate is present, license plate holder relocation and/or modification required to install hitch, see 49802 or 5443 sold separately.

Figure 1.

Receiver Shown In Proper Position

Equipment Required: Utility Knife

Wrenches: 8mm, 21mm deep

well socket, & 7/8”

Fastener Kit: 65053F

Forward hole.

Existing holes

to be modified

Access holes on

E-150 & 250

Loosen bolts (2)

per frame rails

Do not remove

Existing holes

to be modified.

Plastic rivets

removed.

See Step 2.

Feed fasteners

between frame rail

and bumper bracket

Figure 2.

E-150 & E-250

Figure 3.

E-350 & E-450

Frame rail

Bumper bracket

Frame rail

Bumper

bracket

Do not

remove

Forward hole.

Existing holes

to be modified

Existing slot

Frame

rail

Frame rail

Bumper bracket

Fascia

1 2 3 4

Inhaltsverzeichnis

Seite 1 - Ford Econoline

Front Mounted ReceiverInstallation InstructionsFord EconolineNote: Fascia trim required. Obtain vehicle owne

Seite 2

Attelage à montage avantInstructions d’installationFord Econoline Remarque : Découpage de la carrosserie requis. Obtenir

Seite 3

Receptor instalado por el frenteInstrucciones de instalación Ford EconolineNota: Se requiere recorte de la placa protectora. Obten

Seite 4 - Installation Instructions

Front Mounted ReceiverInstallation InstructionsFord EconolinePart Numbers:650534. Trim lower fascia as shown in Figure 4.a. Locate the cent

Kommentare zu diesen Handbüchern

Keine Kommentare

Draw-tite 65053 FRONT MOUNT RECEIVER Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für das Auto Draw-tite 65053 FRONT MOUNT RECEIVER herunter. Draw-Tite 65053 FRONT MOUNT RECEIVER User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für das Auto Draw-tite 65053 FRONT MOUNT RECEIVER