Draw-tite 24892 SPORTFRAME HITCH Bedienungsanleitung PDF herunterladen

Installation Instructions

Nissan Juke

Front Wheel Drive

Part Numbers:

Hitch Shown In Proper Position

Wiring Access Location:

Equipment Required: Pull wires (provided) ,

lubricant or soapy water.

Wrenches: 3/4

Drill Bits: 1/2

3/4”

Bridge

Do Not Exceed Lower of Towing Vehicle

Manufacturer’s Rating or

Drawbar must be used in the

RISE position only.

Drawbar Kit:

3593

Fastener Kit: 24892F

24892

60311

77280

2000 LB (908 Kg) Max Gross Trailer Weight

200 LB (90.8 Kg) Max Tongue Weight

Tie down

bracket

Tie down

hook

Tie down

bracket

1.00

3/8”

Frame rail

Access hole

Remove rubber isolator

at this location

Frame rail

Fascia

Tie down

hook

Accessory Rating

Note: sort hardware prior to hitch installation to confirm bolt lengths are installed in proper locations.

1. Lower exhaust by removing rubber isolators from muffler hangers. Spraying a lubricant or soapy water on the metal hanger rod and the

rubber isolator helps removal.

2. Enlarge access hole to allow for block and carriage bolt use ½” drill bits (See Figure 2.) or use a die grinder to enlarge the access hole in

bottom of frame rail. See Figure 2. Paint any bare metal.

3. Feed pull wires with spacer and bolt (item 5 & 6) into frame rail thru enlarge access hole and out the attachment holes. Leave pull wires

attached.

4. Raise hitch into position with bridge over tailpipe and tie down bracket over tie down hook. Feed pull wires thru holes on hitch bracket and

continue to pull fasteners through frame rail and adjacent holes in brackets. Carefully remove pull wires and attach conical washers and nut

finger tight only (Be careful not to push fastener back into frame rail).

5. Install ½-13 x 2.50 carriage bolt into tie down bracket slot, thru tie down hook and attach spacer, conical washer and nut finger tight only.

6. Reinstall muffler .

7. Torque all fasteners to specifications shown below.

8. Paint any exposed metal.

Sheet 1 of 3 24892N 8-14-12 Rev. A

Qty. (1) Carriage bolt ½-13 X 2.50 GR5

Qty. (3) Hex nut ½-13

Qty. (1) Spacer ¼‘” X 1.50 X 3.00

Qty. (2) Carriage bolt ½-13 X 1.75 GR 5

Qty. (3) Conical washer

Qty. (2) Spacers ¼” X 1.00 X 3.00

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

Form F206 Rev A 5605

Tighten all ½-13 GR 5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)

Access hole modification to allow

for block and carriage bolt.

bracket

Figure 1.

Figure 2.