Draw-tite 24873 SPORTFRAME HITCH Bedienungsanleitung PDF herunterladen

Installation Instructions

Fiat 500 and 500c (convertible)

Part Numbers:

77255, 24761U-Haul

24873, 60289

Do Not Exceed Lower of Towing Vehicle

Manufacturer’s Ratin

Drawbar Kit:

Hitch Shown In Proper Position

Wiring Access Location: PC1, PC2

Equipment Required: Fish wire (included)

Spray lube

Wrenches: 7/8, M8, M13

Drill Bits: None

2000 LB (908 Kg) Max Gross Trailer Weight

200 LB (91 Kg) Max Tongue Weight

Drawbar must be used in the

Rise position only.

Drawbar

Kit:

3593

Fastener Kit: 24873F

BUMPER SUPPORTS

USE ONLY IF

NO SPARE TIRE

LIFT

SPARE TIRE LIFT

RUBBER PLUG

FORWARD

ATTACHMENT

HOLE

FORWARD

FASCIA SUPPORTS

1. Lower spare tire if it has one. Raise vehicle.

If spare tire is present lower spare tire lift by removing (2) m8 screws and (1) m8 nut with m13 socket Remove rubber plug

frame and fish wire

Qty. (4) Carriage Bolt – 1/2 – 13 x 4.00 gr5

Qty. (1) Block – 1 x 3 x 1/4

Qty. (2) Plates – 3-1/16 x 6-3/4 x 3/16

Qty. (2) Flat Washer – 1/2

Qty. (5) Washer – Conical toothed 1/2”

Qty. (1) Bolt – M8x1.25 x 30mm

Qty. (5) Nut – 1/2 -13

Qty. (1) Washer conical toothed – 3/8”

Qty. (1) Carriage Bolt – 1/2 – 13 x 1-3/4 gr5

spare

tire

present

lower

spare

tire

lift

removing

(2)

screws

and

(1)

nut

with

m13

socket

Remove

rubber

plug

frame

and

fish

wire

item 5 and 6 into existing hole. Replace rubber plug and spare tire lift. Leave fish wire on bolt.

3. Remove two fascia mounting screws from fascia supports with m8 wrench.

4. Lower muffler by removing the two pins from the two rubber mounts at the rear of the muffler. It helps if the pins are lubed and the exhaust is gently

pulled rearward.

5. Place plates (item 2) on top of bumper support as shown and install carriage bolts (item 1) Hint; It is easier if the plate is fed in from the center with

the outer bolt already in the plate.

6. Gently pull the fascia down and slide the hitch between the fascia and its support. Put washer (item 7) in place and thread the fish wire through

proper hole in bracket.

7. Raise hitch into place as shown and loosely install washers and nuts to bolts (item 1). Pull fish wire with bolt into position, remove the fish wire and

install washer and nut. Install m8 bolt and washer (item 8 and 9) thru bracket and into weld nut in frame.

Push hitch forward and tighten all fasteners

Push

hitch

forward

and

tighten

all

fasteners

Tighten all 1/2” fasteners with torque wrench to 50 Lb.-Ft. (68 n*m)

z 2011 Cequent Performance Products

Sheet 1 of 3 24873N 07-06-11 Rev. C

Tighten all M8 fasteners with torque wrench to 20 Lb.-Ft. (27 n*m)

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry

of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and

wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE

J684.

Form F206 Rev A 5605

1 2 3

Inhaltsverzeichnis

Seite 1 - Installation Instructions

Installation InstructionsFiat 500 and 500c (convertible)Part Numbers:77255, 24761U-Haul24873, 60289Do Not Exceed Lower of Towing Vehicle Manufacturer’

Seite 2 - Instructions d’installation

Instructions d’installationFiat 500 and 500c (convertible)Numéros de pièce :77255, 24761U-Haul24873,60289Ne pas excéder les spécifications de poids du

Seite 3 - Instrucciones de instalación

Instrucciones de instalaciónFiat 500 and 500c (convertible) Números de partes:77255, 24761U-Haul24873, 60289No supere el valor inferior entre la calif

Kommentare zu diesen Handbüchern

Keine Kommentare

Draw-tite 24873 SPORTFRAME HITCH Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für das Auto Draw-tite 24873 SPORTFRAME HITCH herunter. Draw-Tite 24873 SPORTFRAME HITCH User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für das Auto Draw-tite 24873 SPORTFRAME HITCH